MPC56XX FLASH SOFTWARE DRIVER DOWNLOAD
But when I tried again to connect after having the version confirmed , I kept getting the error of “Can’t communicate with the target processor! Greetings, Whenever you see that you cannot communicate to the target processor, I advise to close the software and power cycle your board and the multilink. You could use the “reset” command but that will reset the chip not power cycle and re-enter debug mode. Then you will have better results. You may need to disable them for you to be able to flash program the chip. Close this comparisson table. Cart New Account Login.
|Date Added:||22 June 2013|
|File Size:||47.31 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Read more about how to use Diagnostics mode:. Download 64K Starter Edition at no cost! Cart New Account Login. If you purchase the full version of the software, then you will not softwage this limitation. You could use the “reset” command but that will reset the chip not power cycle and re-enter debug mode.
I’m not sure what I need to do to achieve my goal. Comment 2 Takao Y. Tuesday, March 8, Next thing you should check is if your board has some kind of system bus chip or external watchdog.
PEmicro | Experts in Embedded tools for Flash Programming and Development
What should I do? I was able to connect to the processor once and got to the stage of selecting the PCP file. If you do not see an algorithm for your device, you may request an algorithm for your device free of charge.
I didn’t realize the difference until now.
MPC5746C flash programming via JTAG
Is there some simple way to do this from a Windows based application? Stand-Alone Flash Programming Create new topic. You may need to disable them for you to be able to flash program the chip. Close this softward table.
Read more about how to use Diagnostics mode: Is there a “run” command in the progppcnexus to run through the code? PEMicro Staff – March 10, – I didn’t get a chance to select PCP file since I needed to confirm the version of my Freescale device. Usually communication gets lost because the watchdog has caused the chip to reset. Then you will have better results. sofhware
JG MPC56xx/SPC – SMOK
Comment 4 Takao Y. Which Devices Are Supported? Takao Yamada Comment 2.
Cart New Account Login. Programming algorithms must make assumptions about how the flash is connected to the MCU, but if these assumptions are off, the “Chip Select Diagnostics Mode” in our PROG software can help sofwtare user determine what changes may need to be made to the programming algorithm to match their device setup.
Takao Yamada Comment 4 Takao Y. I also tried uninstall the driver of the Multilink USB device and reinstalling it but flasj still doesn’t let me connect. PEMicro Staff – March 23, – PEMicro Staff – March 8, –